Ductility of a 60-Story Shearwall Frame-Belt Truss (Virtual Outrigger) Building

Authors

  • Pudjisuryadi P. Department of Civil Engineering, Faculty of Civil Engineering and Planning, Petra Christian University, Surabaya
  • Lumantarna B. Department of Civil Engineering, Faculty of Civil Engineering and Planning, Petra Christian University, Surabaya
  • Tandya H. Alumnus, Department of Civil Engineering, Faculty of Civil Engi-neer¬ing and Planning, Petra Christian University, Surabaya
  • Loka I. Alumnus, Department of Civil Engineering, Faculty of Civil Engi¬neer¬ing and Planning, Petra Christian University, Surabaya

:

https://doi.org/10.9744/ced.14.1.19-25

Keywords:

Ductility, shear wall frame–belt truss, static non-linear push over analysis, dynamic non-linear time history analysis.

Abstract

Researches have been conducted to study Shearwall-frame combined with belt truss as structural system (SFBT), in which the post-elastic behavior and ductility of this structural system are explored. A 60-story SFBT building, with a ductility set equal to 3.75 (value for fully ductile cantilever wall) is considered. The Elastic Response Spectrum used for design is taken from Zone 2 of Indonesian Seismic Map. Capacity design method according to Indonesian Concrete Code is employed. The seismic performance is analyzed using static non-linear push-over analysis and dynamic non-linear time-history analysis. Spectrum consistent ground motions of the May 18, 1940 El-Centro earthquake N-S components scaled to maximum accelerations of various return periods (50, 200, and 500 years) are used for analysis. The results of this study show that plastic hinges mainly developed in beams above the truss, columns below the truss, and bottom levels of the wall. The building shows no indication of structural instability.

References

Nair, R. S., Belt Trusses and Basements as ‘Virtual’ Outriggers for Tall Buildings, Engineering Journal, AISC, Fourth Quarter/1998, pp. 140-146.

Adhi, A. and Tenggara, W.A., Pemakaian Belt Truss sebagai Virtual Outrigger, Undergraduate Thesis. Faculty of Civil Engineering and Planning, Department of Civil Engineering. Petra Christian University, Surabaya, Indonesia, 2000.

Lumantarna, B., Fransisca, and Rosilawati, Perilaku Belt Truss sebagai Virtual Outrigger, Proc. HAKI Conference 1999, September 1999 Jakarta, Indonesia, pp. 101-109.

Lumantarna, B., The Effectiveness of Belt Truss As Virtual Outrigger for Tall Building, Proc. ICCMC/IBST 2001 International Conference on Advanced Technologies in Design, Construction and Maintenance of Concrete Structures, March 2001 Hanoi, Vietnam, pp. 140-146.

Pudjisuryadi, P., Lumantarna, B., Daktilitas Struktur Shearwall–Frame dengan Belt Truss sebagai Virtual Outrigger, Civil Engineering Dimension, 8(1), March 2006, pp.41-46.

Pudjisuryadi, P., Lumantarna, B., A Preliminary Study on the Ductility of Shear Wall Frame–Belt Truss (Virtual Outrigger) System, Proc. The Tenth East Asia-Pacific Conference on Structural Engineering & Construction (EASEC-10), August 3-5 2006 Bangkok, Thailand, pp. 695-700.

Badan Standarisasi Nasional (BSN), Standar Nasional Indonesia (SNI) 03-1726-2002, Tata Cara Perencanaan Ketahanan Gempa untuk Bangunan Gedung.

Prasetio, A., Sumendap, H.S., Studi Lanjut tentang Daktilitas Struktur pada Sistem Shearwall Frame–Belt Truss sebagai Virtual Outrigger, Undergraduate Thesis. Faculty of Civil Engineering and Planning, Department of Civil Engineering. Petra Christian University, Surabaya, Indonesia, 2008.

Standar Nasional Indonesia (SNI) 03-2847-2002, Tata Cara Perencanaan Struktur Beton Untuk Bangunan Gedung.

Lumantarna, B., Lukito, M., RESMAT, Sebuah Program Interaktif untuk Menghasilkan Riwayat Waktu Gempa dengan Sppektrum Tertentu, Proc. HAKI Conference 1997, August 13-14 1997 Jakarta, Indonesia, pp. 128-135.

Susila, I.G.M., Seismic Microzonation and Site Spesific Respons Analysis for Denpasar, Thesis. Geotechnical Engineering of Graduate Program, Institute of Technology, Bandung, Indonesia, 2000.

Habibullah, A., SAP2000-Linear and Nonlinear Static and Dynamic Analysis and Design of Three-Dimensional Structure, Computer and Structures, Inc., Berkeley, California, USA, 2006.

International Committee on Concrete Model Code. Asian Concrete Model Code, Level 1 & 2 Documents, Second Draft. Japan, 1999.

Downloads

Published

2012-03-14

How to Cite

P., P., B., L., H., T., & I., L. (2012). Ductility of a 60-Story Shearwall Frame-Belt Truss (Virtual Outrigger) Building. Civil Engineering Dimension, 14(1), 19-25. https://doi.org/10.9744/ced.14.1.19-25

Issue

Vol. 14 No. 1 (2012): MARCH 2012

Section

Articles

License

Authors who publish with this journal agree to the following terms:
  1. Authors retain the copyright and publishing right, and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
  2. Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
  3. Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) followingthe publication of the article, as it can lead to productive exchanges, as well as earlier and greater citation of published work (See The Effect of Open Access).