Finite Element Analysis of The Effect of Fiber Content on The Flexural Strength of SFRC Beams with Steel Rebars

Authors

  • Ilham Nurhuda Diponegoro University
  • Blinka Hernawan Prasetya Diponegoro University
  • Nuroji Diponegoro University
  • Yulita Arni Priastiwi Diponegoro University

:

https://doi.org/10.9744/ced.26.2.101-110

Keywords:

finite element, fiber content, steel fiber, RC beams, flexural strength, crack pattern

Abstract

This research aimed at studying the effect of fiber content on the flexural strength and behavior of steel fiber reinforced concrete (SFRC) beams with steel rebars. The study employed finite element (FE) analysis to simulate the behavior of SFRC beams. The simulation results of the FE model were validated against experimental data. Subsequently, the validated model was utilized to analyze the strength and crack patterns of SFRC beams with steel rebars in comparison to conventional RC concrete beams without fibers. The parametric study indicates an average 9% increase in RC beam capacity for every 1% increment in fiber volume fraction. Moreover, this study reveals more substantial effects of steel fibers on beams with low reinforcement ratios. Crack analysis shows that cracks in the SFRC beams are distributed more evenly compared to plain RC beams at regions with the same bending moment, indicating enhanced strength to sustain loads, reduced deflection, and improved beam ductility.

References

Vijayan, D.S., et al., A Comprehensive Analysis of the Use of SFRC in Structures and Its Current State of Development in the Construction Industry, Materials, 15(19), 2022, pp. 1-25.

Altun, F., Haktanir, T., and Ari, K., Effects of Steel Fiber Addition on Mechanical Properties of Concrete and RC Beams, Construction and Building Materials, 21(3), 2007, pp. 654–661.

Soulioti, D.V., Barkoula, N.M., Paipetis, A., and Matikas, T.E., Effects of Fibre Geometry and Volume Fraction on the Flexural Behaviour of Steel-fibre Reinforced Concrete, Strain, 47, 2011, pp. 535–541.

Soutsos, M.N., Le, T.T., and Lampropoulos, A.P., Flexural Performance of Fibre Reinforced Concrete Made with Steel and Synthetic Fibres, Construction and Building Materials, 36, 2012, pp. 704–710.

Wang, Z.L., Wu, J., and Wang, J.G., Experimental and Numerical Analysis on Effect of Fibre Aspect Ratio on Mechanical Properties of SRFC, Construction and Building Materials, 24(4), 2010, pp. 559–565.

Nataraja, M.C., Dhang, N., and Gupta, A.P., Stress-Strain Curves for Steel-Fiber Reinforced Concrete under Compression, Cement and Concrete Composites, 1999.

Ramadoss, P., Li., L., Fatima, S., and Sofi, M., Mechanical Performance and Numerical Simulation of High-Performance Steel Fiber Reinforced Concrete, Journal of Building Engineering, 64(October 2022), 2023.

Thomas J. and Ramaswamy, A., Mechanical Properties of Steel Fiber-Reinforced Concrete, Journal of Materials in Civil Engineering, 19(5), 2007, pp. 385–392.

Furlan S. and De Hanai, J.B., Shear Behaviour of Fiber Reinforced Concrete Beams, Cement and Concrete Composites, 19(4), 1997, pp. 359–366.

Mansur, M.A., Ong, K.C.G., and Paramasivam, P., Shear Strength of Fibrous Concrete Beams without Stirrups, Journal of Structural Engineering, 112(9), 1986, pp. 2066–2079.

Campione G. and Mangiavillano, M.L., Fibrous Reinforced Concrete Beams in Flexure: Experimental Investigation, Analytical Modelling and Design Considerations, Engineering Structures, 30(11), 2008, pp. 2970–2980.

Choi, K.K., Park, H.G., and Wight, J.K., Shear Strength of Steel Fiber-Reinforced Concrete Beams without Web Reinforcement, ACI Structural Journal, 104(1), 2007, pp. 12–21.

Mindess, S. and Zhang, L., Impact Resistance of Fibre-Reinforced Concrete, Proceedings of the Institution of Civil Engineers: Structures and Buildings, 162(1), 2009, pp. 69–76.

Slater, E., Moni, M., and Alam, M.S., Predicting the Shear Strength of Steel Fiber Reinforced Concrete Beams, Construction and Building Materials, 26(1), 2012, pp. 423–436.

Gholamhoseini A., Khanlou, A., MacRae, G., Scott, A., Hicks, S., and Leon, R., An Experimental Study on Strength and Serviceability of Reinforced and Steel Fibre Reinforced Concrete (SFRC) Continuous Composite Slabs, Engineering Structures, 114, 2016, pp. 171–180.

Watts, M.J., Amin, A., Gilbert, I.R., Kaufmann, W., and Minelli, F., Simplified Prediction of the Time Dependent Deflection of SFRC Flexural Members, Materials and Structures/Materiaux et Constructions, 53(3), 2020.

Khaloo, A.R. and Afshari, M., Flexural Behaviour of Small Steel Fibre Reinforced Concrete Slabs, Cement and Concrete Composites, 27(1), 2005, pp. 141–149.

Salehian, H., Barros, J.A.O., and Taheri, M., Evaluation of the Influence of Post-Cracking Response of Steel Fibre Reinforced Concrete (SFRC) on Load Carrying Capacity of SFRC Panels, Construction and Building Materials, 73, 2014, pp. 289–304.

Abdul-Ahad, R.B. and Aziz, O.Q., Flexural Strength of Reinforced Concrete T-Beams with Steel Fibers, Cement and Concrete Composites, 21(4), 1999, pp. 263–268.

Meda, A., Minelli, F., and Plizzari, G.A., Flexural Behaviour of RC Beams in Fibre Reinforced Concrete, Composites Part B: Engineering, 43(8), 2012, pp. 2930–2937.

Abbas, A.A., Syed Mohsin, S.M., and Cotsovos, D.M., A Simplified Finite Element Model for Assessing Steel Fibre Reinforced Concrete Structural Performance, Computers & Structures, 173, 2016, pp. 31–49.

Beshara, F.B.A. Mustafa, T.S., Mahmoud, A.A., and Khalil, M.M.A., Constitutive Models for Nonlinear Analysis of SFRC Corbels, Journal of Building Engineering, 28, 2020, pp. 101092.

Campione, G., Simplified Flexural Response of Steel Fiber-Reinforced Concrete Beams, Journal of Materials in Civil Engineering, 20(4), 2008, pp. 283–293.

Campione, G., Flexural Behavior of Steel Fibrous Reinforced Concrete Deep Beams, Journal of Structural Engineering, 138(2), 2012, pp. 235–246.

Ferreira, D. and Manie, J., eds., DIANA User’s Manual Release 104, DIANA FEA bv, (2020).

Selby, R.G. and Vecchio, F.J., A Constitutive Model for Analysis of Reinforced Concrete Solids, Canadian Journal of Civil Engineering, 24, 1997, pp. 460–470.

Abbass, W., Khan, M.I., and Mourad, S., Evaluation of Mechanical Properties of Steel Fiber Reinforced Concrete with Different Strengths of Concrete, Construction and Building Materials, 168, 2018, pp. 556–569.

De Nicolo, B., Pani, L., and Pozzo, E., Strain of Concrete at Peak Compressive Stress for A Wide Range of Compressive Strengths, Materials and Structtures, 27(4), 1994, pp. 206–210.

Lok, T.S. and Xiao, J.R., Flexural Strength Assessment of Steel Fiber Reinforced Concrete, Journal of Materials in Civil Engineering, 11(3), 1999, pp. 188–196.

Seo, J., Lee, J., and Lopez, M.M., Parametric Study on Shear Performance for Steel Fiber Reinforced Concrete Beams, Advances in Structural Engineering, 18(7), 2015, pp. 1115–1127.

Popovics, S., A Numerical Approach to the Complete Stress-Strain Curve of Concrete, Cement and Concrete Research, 3, 1973, pp. 583–599.

Kytinou, V.K., Chalioris, C., and Karayannis, C., Analysis of Residual Flexural Stiffness of Steel Fiber-Reinforced Concrete Beams with Steel Reinforcement, Materials, 13(2698), 2020, pp. 1–24.

Yang, M., Huang, C., and Wang, J., Characteristics of Stress-Strain Curve of High Strength Steel Fiber Reinforced Concrete under Uniaxial Tension, Journal Wuhan University of Technology, Materials Science Edition, 21(3), 2006, pp. 132–137.

Abdul-Razzak, A.A. and Ali, A.A.M., Influence of Cracked Concrete Models on the Nonlinear Analysis of High Strength Steel Fibre Reinforced Concrete Corbels, Composite Structures, 93(9), 2011, pp. 2277–2287.

Lin, W.T., Huan, R., Lee, C.L., and Hsu, H.M., Effect of Steel Fiber on the Mechanical Properties of Cement-Based Composites Containing Silica Fume, Journal of Marine Science and Technology, 16(3), 2008, pp. 214–221.

Kim, K.S., Lee, D.H., Hwang, J.H., and Kuchma, D.A., Shear Behavior Model for Steel Fiber-Reinforced Concrete Members without Transverse Reinforcements, Composites Part B: Engineering, 43(5), 2012, pp. 2324–2334.

Barros J.A.O., Post-cracking Behaviour of Steel Fibre Reinforced Concrete, Materials and Structures/Materiaux et Constructions, 38, 2005, pp. 47–56.

Tlemat, H., Pilakoutas, K., and Neocleous, K., Modelling of SFRC using Inverse Finite Element Analysis, Materials and Structures, 39(286), 2006, pp. 221–233.

fib Model Code 2010, Model Code for Concrete Structures, Federation Internationale du Beton (fib), 2013.

Oh, B.H., Lim, D.H., Yoo, S.W., and Kim, E.S., Shear Behaviour and Shear Analysis of Reinforced Concrete Beams Containing Steel Fibres, Magazine of Concrete Research, 50(4), 1998, pp. 283–291.

Yoo, D.Y. and Moon, D.Y., Effect of Steel Fibers on the Flexural Behavior of RC Beams with Very Low Reinforcement Ratios, Construction and Building Materials, 188, 2018, pp. 237–254.

Downloads

Published

2024-09-13

How to Cite

Nurhuda, I., Prasetya, B. H., Nuroji, N., & Priastiwi, Y. A. (2024). Finite Element Analysis of The Effect of Fiber Content on The Flexural Strength of SFRC Beams with Steel Rebars. Civil Engineering Dimension, 26(2), 101-110. https://doi.org/10.9744/ced.26.2.101-110